1. Die installation

(1) Install the downpunch: unscrew the downpunch fixing screw, turn the handwheel to raise the downpunch core rod to the highest position, insert the downpunch into the hole of the downpunch core rod (pay attention to make the notch slope of the downpunch align with the downpunch fastening screw, and insert it to the bottom), and finally tighten the downpunch fixing screw.

(2) Installation of up-punch: unscrew the up-punch fastening nut, insert the up-punch core rod into the hole of the up-punch core rod, and insert it to the end. Use a wrench to clamp the hexagon at the lower part of the up-punch core rod, and tighten the up-punch fastening nut.

(3) Install the middle mold: unscrew the set screws of the middle mold, flatten the middle mold and put it into the hole of the middle mold bedplate, at the same time, make the down-punch enter the hole of the middle mold, press it to the bottom, and then tighten the set screws of the middle mold. When placing the middle mold, pay attention to flatten the middle mold to prevent it from getting stuck and damaging the hole wall.

(4) Turn the handwheel by hand to make the up-punch slowly fall into the middle mold hole, and observe whether there is collision or friction. If there is collision or friction, loosen the set screws (two) of the middle mold platen, adjust the fixed position of the middle mold platen, so that the up-punch enters the middle mold hole, and then tighten the set screws of the middle mold platen, so that the installation is qualified until the up-punch enters the middle mold without collision or friction.

                 

                 

                 

               

                 

                 

Suzhou Pharma Machinery Co.,Ltd.

2023/01/13

Mia