7. Overlapping tablet

Fault condition:

Two times of feeding and pressing into one piece

Cause of failure:

When the tablets are adjusted, they are not ejected and the hand wheel is reversed to make the feeder feed repeatedly, resulting in overlapping tablets.

Fault prevention and treatment:

Be careful not to reverse during adjustment. When the materials have been repeatedly fed but the overlapping tablets have not been formed, the hand wheel can be slowly reversed to push the tablets up, brush off the repeatedly added materials and pull out the tablets. If the overlapping tablets have been pressed and jacked, it shall be handled according to the jacking conditions

Treatment after jacking

(1) in case of jacking during electric tablet pressing, turn off the power immediately to avoid burning the motor.

(2) when the jacking condition is light, turn the hand wheel manually to make the upward impact pass through the "dead center" (but it cannot be reversed to avoid repeated feeding of the feeder and more serious jacking).

(3) in case of serious jacking, loosen the locking nut of the connecting rod, turn the upper punch rod to make it rise to reduce the pressure, and then turn the hand wheel to eject the tablets. Then readjust the hardness of the tablets.

Suzhou Pharma Machinery Co., Ltd a manufacturer integrating design, production and installation, introduces advanced production lines, and can design and produce according to customer requirements. Make products with the spirit of craftsmanship of excellence.The product quality is guaranteed and the service is perfect. The manufacturer's direct sales saves you intermediate costs.we can provide you with a full set of pharmaceutical production lines and clean room construction, and provide you with one-stop service. It is your trusted partner. Welcome to cooperate with Suzhou Pharma machinery for win-win!

                 

                 

                 

Suzhou Pharma Machinery Co.,Ltd.

2022/05/01

Mia