Cleanroom Antistatic ESD Dust Remove Sticky Mat for Electricity Factory Hospital

Method of application:
1.When using the sticky mat, first tear off the protective layer of the adhesive surface from the opening on the back, and then put it evenly on the floor of the access, the ground must be clean;

2. After pasting, flatten the sticky mat to the ground, and then tear off the protective layer of the sticky mat surface from the front opening ;

3.During use, if the surface of the film is covered with dust during use, this layer is removed from the opening, so that the next layer of clean film can be used.
Method: First, slowly separate the four corners of the dust pad from the pad, then move closer to the middle, wrap the dust inside, and fold the film inward until it is small enough to discard. In this way, the pollutants attached to the dust removal pad will not fly around to ensure the dust removal effect.

Features:

• Good Quality

• High Stickness

• Environmental Protection 

• Material Safety & Tasteless

• Easy replacement

• Smooth and clean surface

• Non-transferring adhesive

• Easy sheet -to -sheet removal

• Numbered corner tabs for easy tracking