Catalyst tablet press can not be pressed into tablets or the cause of tableting is not good and the solution
Catalyst tablet press is mainly suitable for electronics, food, daily necessities, pharmaceuticals and other industrial sectors. The outer casing is fully enclosed, and the material is made of stainless steel, which meets the GMP standard. Equipped with a transparent observation window, you can clearly see the working conditions of the machine and can be fully opened, which is easy to see and maintain the inside. It has the characteristics of high pressure, large tablet pressing range, and can press ordinary, special-shaped, circular and other shapes of tablets. It is especially suitable for multi-variety and small-batch production. Mechanical and electrical integration, all controllers and adjustment devices are concentrated on one side of the body, easy to operate. Equipped with a pressure overload protection device to avoid machine damage. The transmission mechanism adopting oil invasion lubrication is sealed under the machine body, which prolongs the service life and avoids cross-contamination. The punching die can be used in common with the tablet press machine. It can be used for pressing candy tablets, milk tablets, chewable tablets, buccal tablets, glucose tablets, etc. Reasons and solutions for catalyst tablet press failure or poor tableting effect: The formulation of auxiliary materials such as drug powder raw materials, slip materials, viscous agents, and granulation conditions all directly affect the quality of tablets. And often due to improper granulation of ingredients, it cannot be formed into tablets, or even damage the machine. Therefore, this machine cannot be used for semi-fixed or moist tablets. During use, if it is found that the pressure has been adjusted to a considerable level and still cannot be pressed into tablets, or even though it is pressed into pieces, there are too loose, starting, fragments, pitting, powder falling, etc., you should find out the reasons from the direction of raw materials and ingredients and solve them. Do not blindly adjust and increase the pressure to avoid damage to the machine. In addition, although the hardness of the tablets extruded from some materials is not high, they have certain toughness, and their impact resistance is not bad. Therefore, the requirements for transportation and storage should be met. Don’t just focus on the hardness to avoid excessive tablet pressure. damage the machine.