Assembly expertise for powder tablet press dies

The rotary tablet press has high pressure and can press ordinary, special-shaped, ring-shaped tablets and other shapes. There can be 17 pairs of dies on the turntable, and 17 tablets can be pressed in one rotation. It is especially suitable for various types and mass production. It is a machine and pharma machinery for manufacturing tablets in various pharmaceutical, food, chemical and other industries. Professional knowledge of die assembly for rotary tablet press: Before the die assembly, the silo, drainage powder feeder, feeding rack and other components should be removed, and the turntable table, die hole and assembled die should be wiped one by one, and press the following The process is assembled. 1. Middle mold device: Take out the middle mold fastening screws on the turntable one by one and make it even with the outer circle of the turntable. Do not let the middle mold fit in and touch the top of the screw. The middle mold installation is very tight. If it is flat, it can be punched with a middle mold (any special tool), then the upper punching machine will penetrate it, use a hammer to punch it lightly, and the middle mold will enter the mold. The plane of the hole should not be higher than the plane of the rotary table to meet the standard, and then tighten the screws; 2. Upper punching device: The tongue at the gap of the upper slide rail should be pulled up, and the end of the middle rod should be coated with cooking oil. , insert them into the holes one by one, turn the punch with your thumb and fingers, and check that the top of the head enters the middle mold left and right and rotates flexibly. If there is no hard rubbing, it is up to the standard. After everything is installed, the inlay tongue should be pulled down; 3. Punching device: open the side door on the main body and install it through the main round hole. The installation method is the same as that of the upper punching device. After the installation is correct, the disc must be flattened; 4. After all the dies are set, install the removed parts according to the original position , continue to rotate the test handwheel with your hand, so that the turntable rotates 1-2 turns, observe the left and right rushing into the middle mold hole and the behavior on the curve guide, make sure it is flexible without impact and hard rubbing, start the motor, and make the air switch run for 2 -3min, stable and normal can be put into production. Rotary tablet press machine is a kind of equipment for continuously tableting candy. It can press various granular raw materials into round shapes, and can also be pressed into special-shaped tablets of various shapes. In chemical plants, food, health care products, electronic devices and other fields, it is mainly used for tablet production in the pharmaceutical industry.
SUZHOU PHARMA MACHINERY CO.,LTD., as well, confirms that consumers who want ethically produced goods do the work of looking for them.
go to PHARMA MACHINERY to get an amazing offer at favorbale price. the CUSTOM SOLUTION SERVICES extraction machine actually works and is worth a try.
SUZHOU PHARMA MACHINERY CO.,LTD.’s model also predicts (i) a positive effect of management on firm performance; (ii) a positive relationship between product market competition and average management quality (part of which stems from the larger covariance between management with firm size as competition strengthens); and (iii) a rise (fall) in the level (dispersion) of management with firm age.