What are the structure and application regulations of special-shaped die tablet press1

For the structure of the tablet press with special requirements, some matters should be paid attention to in use. The structure and application requirements of the special-shaped die tablet press machine: if the tablet is subjected to the bundle of a special-shaped die, the die has certain positioning requirements, such as square, triangle, ellipse and other shapes. The upper punch of the tablet press wheel has requirements on the structure of the tablet press. The requirement to move forward on the die is due to the fact that the upper punch must be provided with a direction key, which is adapted to the upper punch of the wheel in the setup phase. The lower punch of the tablet press does not leave the middle die hole during operation, and no other solutions are required. The use of special-shaped punches to control the tablet punches cannot be turned over safely, and can only move up and down along the left and right guide rails. When the turntable is driven, the punch and guide rail will roll and rub against each other, causing the punch and guide rail to damage each other. Therefore, you should pay attention to the gloss when using them, and remember to maintain them in daily work. We should regularly check for looseness and damage. Affected time and uncontrollable punches and intermediate dies