What are the faults and maintenance measures of single-punch tablet press_Tablet press_high speed_single punch_double layer_flower basket_multifunctional rotary tablet press PHA

What are the faults and maintenance measures of the single-punch tablet press?

The smoothness of the friction surface of each stationary part of the single-punch tablet press is an important part to ensure the normal operation of the machine and prolong the service life, especially the important stationary parts (such as the exhibition wheel, main shaft and leather). If the belt shafts and cam tracks are dry in the absence of oil, they will be snappy and unusable. Therefore, before each use, the tablet must be oiled and smoothed over the entire oil cup, oil hole and smooth surface. When running empty, the friction surface is filled with oil film and then put into operation.

Before each shift, it is necessary to check whether the screws of the tablet press are loose. During assignments, attention should always be paid to scrutiny. If loose, tighten it immediately to avoid malfunction.

Before each shift and after each shift, you have to manually test a few pieces and pass the voltage chip after there is no problem.

Single punch tablet presses must always check die quality during tablet compression. If the present invention lacks edges, cracks, deformation or serious wear, it should be replaced in time to avoid failure and damage to the machine and the tablet quality of the single-punch tablet press

The single-punch tablet press is kept clean every day, especially the pressure parts, ejector rods and connecting rod parts. After completing each task, carefully clear the hopper trolley, auxiliary hopper, medium formwork, powder removal residue box, upper, middle and lower mold materials that are not used for the next task, so as not to be confused with the next task mix.

The defects of single-punch tablet press molds should be replaced in time, carefully check whether there are pits on the edge of the middle mold, and the impact marks on the upper and lower molds should be adjusted or replaced in time. To remove the mold, save it.

Before starting, each electrical component of the single punch tablet press should be inspected. For example, whether the inverter has supporting wiring, especially whether the power output terminals and output terminals of the inverter can be connected incorrectly, whether the output power is OK, whether there is a short circuit in the center according to the additional specifications, check whether the terminals are tight and maintain integrity and normal.