The structure and application requirements of special-shaped die tablet press_Tablet Press_High Speed_Single Punch_Double Layer_Flower Basket Type_Multifunctional Rotary Tablet Press PHAR

The structure of the tablet press with special requirements in some aspects is also targeted. On the application side, there are a few more things to be aware of. Let's analyze it below.

Structural and application requirements of special-shaped die tablet press: If the tablet is limited by the molding die, the die has certain positioning requirements, such as square, triangle, oval, etc. The upper punch of the turntable needs the structure of the tablet press. Since the upper punch needs a positioning key, and the upper punch of the turntable is coordinated during the installation process, the requirements for the punch are increased. The lower punch will not leave the middle die hole during operation, and no other processing is required. The special-shaped die is used to restrict the free rolling of the tablet punch, but move up and down along the upper and lower rails. When the turntable is driven, the punch and the guide rail are slid and rubbed, so that the punch and the guide rail wear each other. Therefore, when we use them, we must pay attention to smoothness. We have to remember to do maintenance on a daily basis. If there is no looseness and wear, we should check it regularly, and the affected time and punch cannot be produced.

After the punch and the middle mold are accurately positioned, the forming mold is dried, and the punch is screwed into the hole of the middle mold to make the positioning inaccurate. After the mold is installed, the hand wheel is rolled several times, and there is no special situation before moving. The structure and application requirements of the two-color tablet press: the construction method of the two-color tablet is limited by two materials. In terms of the structure of the tablet press, we mainly carry out the remodeling of the lower guide rail, and then test the two-color tablet. Tablets are filled twice. When we limit the time of the two-color chip, the situation is as follows: the time content of the two materials together does not meet the requirements of the rule, and the filling can be adjusted first, and then the content of the two can be adjusted. The materials are adjusted successively. The limited tablets will split and the hardness will not be coordinated, mainly due to the material, the density of the material, the humidity of the drying, etc. cannot be adjusted well, and the adjusted material is adjusted.