Simple maintenance of the tablet press

Since the exhaust valve of the tablet press is tightened when leaving the factory, first use the handwheel to adjust the pressure screw, and screw the handwheel of the oil drain valve clockwise. At this time, the above two items should not be tightened too tightly. , Just push it up a little bit, swing the handle up and down, stop pressurizing after the pointer of the pressure gauge moves upwards, release the exhaust valve and you will hear a sound of exhaust, then tighten the exhaust valve, turn it counterclockwise Open the oil valve handwheel and loosen the pressure screw. Then it is necessary to press the sample, install it according to the instructions of the tableting mold, put the mold in the center of the working space of the tablet press, adjust the pressure screw through the hand wheel, and use the pressure screw to top it, close the oil drain valve up and down Swing the handle. View at the same time