PHARMA newly pill die mold testing for electronics factory

Tablets are a common dosage form in medicinal preparations because of their convenience to take, and the die is an indispensable accessory on the tablet press of commonly used tablet equipment. It is also a very important task to correctly select the appropriate die after the tablet press is purchased. In daily life, many tablet pharmaceutical factories cannot use the tablet press normally due to improper die selection.

In order to enable the users of the pharmaceutical factory to better order the appropriate die, this article will introduce some details. At the same time, it is recommended that the user of the pharmaceutical factory should have a full discussion with the die manufacturer first to reduce possible problems during production.

Due to the characteristics of track design and processing technology, it is recommended that users must purchase products from the same factory for tablet press and die, and do not frequently change mold manufacturers, but choose factories with strong strength and good processing accuracy.

Don't blindly pursue cheap and buy inferior dies, which will eventually damage the tablet press.

Selection of tablet type: The correct selection of tablet type is the first step to the success of a tablet die. For example, chewable tablets require high hardness and are easy to chew. Most of them use bevel-edged flat tablets; those that require film coating can choose shallow-concave tablets. Because there are no binders and lubricants in the raw materials of Chinese tablets, it requires high pressure when compressing tablets, and the tablet shape is preferably shallow. For tablets with high sugar content, the design of the tablet shape is preferably shallow or flat. The middle mold can use alloy steel or hard alloy. The deep-concave sheet die is easy to damage, so use it as little as possible.

This set will fit a range of TDP type including the new TDP 0, TDP 1.5, TDP 5, TDP 6s.

All sets come complete with a centre ring die specific to your machine. Please select your size below.

You can also purchase this design in any other shape or size and for many other machines. Get in touch to discuss your ideas!

Characteristics 1. It is made of carbon steel, bearing steel and chrome 12 2. Digital machining center precision manufacturing, in line with IPT standards 3. Corrosion resistance, impact resistance, wear resistance, high temperature resistance and long service life 4. Interchangeability 100% (no matter round or special mold)