How to solve the problem of deviation and bending when the tablet press is working
1. When the tablet is biased to one side: In addition to poor guidance during feeding, there is also a parallel gap between the upper and lower shafts. Which side the tablet goes to, the gap is too big. When adjusting, stop the drive gear first, and move the landing gear on both sides away. Turn the gear with larger clearance on the shaft down, move to the tooth position, and replace the drive gear. According to the above method, gradually adjust the start-up test pressure until it meets the requirements. (Do not move too many teeth when adjusting) 2. The bending of the pressing material: When the pressing wheel of the tablet press is adjusted too large, the feeding amount should be reduced (when the feeding amount is too large, the adjustment device of the suspension gear allows
What are turnkey cleanroom solutions for pharma facilities? Find that out in this article, and explore SZ Pharma’s state-of-the-art solution.