How to install tablet press mold
Before installing the tablet press mold, the power supply of the tablet press must be cut off, and the cover plate, lower punch, upper guide rail, hopper, and feeder must be removed. Open the right door, gradually clean the working surface of the turntable, the die hole and the mold for installation, and apply some vegetable oil on the outside of the middle die and punch, and adjust the thickness of the film to more than one position 5. Install the middle mold of the tablet press, loosen the embossing screw screwed on the upper guide rail cover, pull out the cover, tap a rod from the punch with the middle mold to knock the middle mold into the hole, and insert the middle mold in the die hole. The middle mold should not be higher than the working surface of the turntable, and should be checked one by one to avoid mistakes. Install
What are turnkey cleanroom solutions for pharma facilities? Find that out in this article, and explore SZ Pharma’s state-of-the-art solution.