5. The feeder is damaged
1.Fault condition:Collide with undershoot
Cause of failure:(1) the out sheet is not adjusted properly, and the down punch is higher than the plane of the middle die(2) the fixed screw of the lower punch is loose, and the lower punch rises out of the plane of the middle die
Fault prevention and treatment:When installing and adjusting the die, pay attention to the looseness of the screw. Immediately press the die to the bottom and tighten the fixing screw.
2.Fault condition:Collide with the lower part of the middle mold
Cause of failure:The fixing screws of the middle mold are loose, and the middle mold rises out of the plane of the middle mold bedplate.
Fault prevention and treatment:When installing and adjusting the die, pay attention to the looseness of the screw. Immediately press the die to the bottom and tighten the fixing screw.
3.Fault condition:Damaged by the upper impact
Cause of failure:(1) reverse rotation and collision during adjustment(2) when adjusting, the position of the upper punch rod is too low, and the rotation of the hand wheel causes collision
Fault prend treatvention ament:Attention during adjustment
Suzhou Pharma Machinery Co., Ltd a manufacturer integrating design, production and installation, introduces advanced production lines, and can design and produce according to customer requirements. Make products with the spirit of craftsmanship of excellence.The product quality is guaranteed and the service is perfect. The manufacturer's direct sales saves you intermediate costs.we can provide you with a full set of pharmaceutical production lines and clean room construction, and provide you with one-stop service. It is your trusted partner. Welcome to cooperate with Suzhou Pharma machinery for win-win!
Suzhou Pharma Machinery Co.,Ltd.
2022/05/01
Mia