Disassembly and installation of tablet press4
1. Disassembly of the middle formwork: Pull out the powder baffle, remove the hopper, unscrew the feeder fixing screws, unscrew the feeder fixing studs and springs, remove the feeder, unscrew the middle formwork fixing screws and spring washers, the middle can Remove mold platen. Installation: Refer to above in reverse order. Pay attention to the alignment when tightening the feeder fastening screw. In order not to damage the feeder hole. 2. Disassembly of the upper punch: loosen the locking nut of the connecting rod, turn the upper punch to separate it from the connecting rod, turn the hand wheel to raise the eccentric housing to the position, turn the eccentric connecting housing to swing the connecting rod of the eccentric housing to the top