Composed of the upper and lower punches and the middle die is the die of the tablet press_tablet press_high speed_single punch_double layer_flower basket_multifunctional rotary tablet press P

Dies for tablet presses

The die of the tablet press is composed of upper and lower punches and a middle die, and the punches and die holes have a good fit.

The tail of the punch of the tablet press is a groove, and the groove is embedded in the convex part of the guide rail or the groove of the guide rail during operation, and moves up and down regularly. There is a groove ring in the middle of the outer circle of the middle mold, which is tightened by the ball end screw to prevent loosening

The shape of the end face of the punch can be flat, shallow concave or deep concave, and can also be engraved with letters, numbers, letters, etc. on the end face to indicate the name, specification, trademark, etc. of the product. The lines are easy to divide into two or divide into three.

The shape of the tablet press machine head and the cross-section of the die hole can be a circle or a special shape such as a triangular oblong circle. However, the size of its section is limited by the pressing force, and it should not exceed the maximum area allowed by the machine, so as not to increase the pressure too much and damage the machine.